U216A BMW Fault Code

Description:

The input turbine speed sensor detects rotation of the input shaft of the input shaft speed sensor transmission. The computer uses that information, along with the output shaft speed sensor to determine if the transmission is operating according to plan. If the computer detects a difference between the input shaft speed , and the expected output shaft speed, it will adjust transmission pump pressure to prevent clutch disc slip. If adding pressure doesn't solve the problem, it will set a trouble code.

U216A Code Symptoms :

When you turn on the ignition, the Service Engine Soon or Check Engine U216A light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the U216A!

Diagnosis And Repairing U216A

U216A OBD2 reports a sensor fault, replacement of the sensor is unlikely to resolve the underlying problem. The fault is most likely to be caused by the systems that the sensor is monitoring, but might even be caused by the wiring to the sensor itself.

How to fix U216A code ?

• Damaged VCT phaser
• Damaged camshaft position (CMP) sensor
• Damaged VCT phaser
• Fuel injectors may be faulty

At this point we are assuming that the fuses and relays are good. You will need to locate the PCM/TCM and the power input signal circuit using your vehicle information source.

Unplug the connector from the PCM/TCM, place the ignition switch in the ON position, and probe the appropriate circuit with the positive test lead of the DVOM.